D4 LED High Bay Light 150 W 4000 K neutral white

LED Damp-Proof Lights for Cellars, Garages and Workshops

LED damp-proof lights are built for rooms where dust, moisture or splash water occur. Their sealed housing with gasket achieves IP65 protection and withstands cleaning with a water jet. Typical locations are cellars, garages, underground car parks, workshops, warehouses and agricultural buildings.

Compared with old fluorescent battens, the LED models save considerable energy and need no tube changes. Length and luminous flux are the main selection criteria: smaller models suffice for cellars, while longer high-output versions make sense in halls. Many luminaires can be linked into continuous light bands.

LED Floodlights for Yards, Facades and Sports Grounds

LED floodlights bring light to large outdoor areas – from the yard and facade to the sports ground. Our range extends from compact 10-watt fittings for the front door to powerful 1.500-watt models for storage yards and sports facilities. All floodlights are weatherproof to IP65 or IP66 and withstand rain, snow and frost.

Some models are available with an infrared motion sensor so the light switches on only when needed, saving energy. Besides wattage, the beam angle matters when choosing: narrow angles reach far, wide angles cover large areas at short distances. We are happy to help determine the right output for your area.

LED Garden Lighting for Outdoor Areas

LED garden lighting stages paths, plants and water features after dark. This category includes inground spotlights for setting into terraces, driveways or lawns as well as underwater lights for ponds, pools and fountains. All fittings are made of stainless steel and protected to IP67 or IP68 depending on the location.

Most models run on 24 volt low-voltage technology, which makes operation outdoors and near water safe. As a planning rule: a few deliberately placed points of light usually work better than uniform continuous lighting. Matching drivers and cable connectors are available in our accessories category.

LED High Bay Lighting for Industry and Commerce

LED high bay lighting has to light large rooms with high ceilings reliably while operating economically. This category includes UFO high bay lights, linear high bay luminaires and canopy fittings for different ceiling heights and uses. Ceiling height, floor area and the type of work are decisive: in warehouses even base brightness matters most, at assembly workstations a low glare rating too.

The beam angle must match the height – narrower for high ceilings, wider for low ones. Compared with old mercury vapour or fluorescent installations, LED high bays often save more than half the energy costs. We are happy to support the design of your hall with a recommendation on quantity and layout.

LED Panels for Office, Practice and Retail

LED panels create a large, evenly lit surface instead of individual bright points. This makes them the standard solution for offices, medical practices, schools and meeting rooms where calm, low-glare light is wanted. We stock backlit panels, in which the LEDs sit behind the diffuser, and edgelit panels with side-fed light and an especially slim design.

The common sizes 60x60, 62x62, 120x30 and 120x60 centimetres are available to suit standard ceiling grids. For ceilings without a grid we offer surface mounting frames that allow direct installation. Watch the UGR value where screen work takes place – the lower, the more comfortable.

LED Track System for Retail and Commerce

An LED track system is the most flexible way to light sales areas. The luminaires are fitted onto the 3-phase busbar via an adapter and can be moved, added to or replaced at any time – with no electrical work at the ceiling. Using the three phases L1, L2 and L3 you switch several lighting groups separately, for example general light and shop window.

This category contains spotlights, linear luminaires, slim panels, food lighting and emergency fittings for the same track. Our adapters fit the common European systems such as Stucchi, Global, Staff, Unipro, Eutrac and Ivela as well as the EU universal standard. If your store layout changes, simply move the luminaires.

LED Street Lighting for Paths, Squares and Residential Areas

LED street lighting replaces old sodium and mercury vapour fittings while considerably reducing energy consumption. This category includes street lights for carriageways, post top luminaires for parks and residential areas, and lanterns in a classic style. All luminaires are protected to IP66 against dust and water jets and built for year-round outdoor use.

Many models allow power and colour temperature to be set by switch, so one fitting serves different situations. In residential areas warm light at 3000 K or below makes sense, as it disturbs residents and insects less. The adapters usually fit poles with 60 and 76 millimetre diameters.

LED Strips for Furniture, Display Cases and Light Lines

LED strips are flexible light bands that can be stuck to almost any surface. Use them to light display cases, shelves, furniture fronts, alcoves and ceiling edges – anywhere a normal luminaire would be too large. We stock two technologies: classic SMD strips with individual visible light points and COB strips that create a continuous, dot-free line of light.

For voltage you can choose between 24 volt low voltage, which needs a driver, and 230 volt strips run directly from the mains. Watch the power per metre: it determines both brightness and the size of driver required. Matching drivers, profiles and connectors are in our accessories category.

LED Accessories for Installation and Operation

A finished lighting project involves more than the luminaire itself. This category contains drivers for LED strips and fittings, motion sensors for retrofitting, brackets and pole adapters as well as cable and plug connectors. Drivers in particular deserve a careful look: the output must match the connected load and should offer around 20 percent headroom so the unit does not permanently run at its limit.

Motion sensors reduce energy costs where light is only needed occasionally – in corridors, stairwells and outdoor areas. Brackets and adapters ensure floodlights and street luminaires sit securely in the intended place. If you are unsure which accessory suits your fitting, just ask us.

D4 UFO LED High Bay Light 150W 18.000lm 90° IP65 4000K

Item number: D4150W46K-1

Category: D4 Series

Lightcolor:: 4000K6000K

69,90 €

including 19% VAT., plus shipping

From	Price per unit
10	59,90 €

Available

Shipping time: 2 - 3 workdays

Description

D4 UFO LED High Bay Light 150 W – 4000 K Neutral White

Neutral-white hall lighting with 18,000 lumens, a 90° beam and IP65 protection – comfortable, natural light for production, workshop and retail.

150 W4000 K neutral white18,000 lm120 lm/WIP6590°CRI > 80

This version of the D4 UFO LED high bay light shines in neutral-white 4000 K. The balanced light looks natural and low-fatigue and is ideal for areas where people work for long periods – production, assembly, workshop or retail. With 18,000 lumens at 150 W, a 90° beam and IP65 protection it combines high brightness with rugged industrial durability.

4000 K neutral whiteNatural colour for low-fatigue, comfortable work.

High brightness18,000 lm at 150 W – 120 lm/W efficacy.

IP65 ratingDust-tight and jet-water protected for industry and damp areas.

90° beam anglePC lens for even illumination of large areas.

Colour temperature 4000 K neutral white
18,000 lumens at 150 W – 120 lm/W
IP65 rating, protection class I
90° beam angle with PC lens
SMD2835 LEDs with current headroom for a long life
Integrated on-board driver (DOB)
CRI > 80, rated life up to 50,000 h
CE and RoHS compliant

Technical data

Model	D4 UFO LED high bay light 150 W
Colour temperature	4000 K (neutral white)
Power	150 W (±10%)
Luminous flux	18,000 lm (±10%)
Efficacy	120 lm/W
Colour rendering (CRI)	> 80
Beam angle	90°
LED type	SMD2835 (216 LEDs)
Input voltage	AC 200–240 V
Input current (max.)	0.75 A
Power factor	≥ 0.9
Driver	Constant current, integrated (DOB)
Dimmable	no
Protection	IP65 / class I
Housing	Aluminium alloy with PC lens
Operating temperature	−20 °C to +50 °C
Dimensions (Ø × H)	296 × 28.7 mm
Net weight	1.1 kg
Rated life	up to 50,000 h
Certification	CE, RoHS
Energy efficiency class	E (EU scale A–G, EU 2019/2015)

Applications

Production and assembly lines
Workshops and vehicle garages
Retail and exhibition areas
Packing and order picking
Quality control and inspection stations

Scope of delivery

1 × D4 UFO LED high bay light 150 W (4000 K neutral white)
Eye bolt with spring washer for suspension
Installation guide

Note: Installation must be carried out by a qualified electrician. 3-wire connection (L / N / PE).