LED Downlight DL6 30W 4000K Neutral White Ø200

LED Damp-Proof Lights for Cellars, Garages and Workshops

LED damp-proof lights are built for rooms where dust, moisture or splash water occur. Their sealed housing with gasket achieves IP65 protection and withstands cleaning with a water jet. Typical locations are cellars, garages, underground car parks, workshops, warehouses and agricultural buildings.

Compared with old fluorescent battens, the LED models save considerable energy and need no tube changes. Length and luminous flux are the main selection criteria: smaller models suffice for cellars, while longer high-output versions make sense in halls. Many luminaires can be linked into continuous light bands.

LED Floodlights for Yards, Facades and Sports Grounds

LED floodlights bring light to large outdoor areas – from the yard and facade to the sports ground. Our range extends from compact 10-watt fittings for the front door to powerful 1.500-watt models for storage yards and sports facilities. All floodlights are weatherproof to IP65 or IP66 and withstand rain, snow and frost.

Some models are available with an infrared motion sensor so the light switches on only when needed, saving energy. Besides wattage, the beam angle matters when choosing: narrow angles reach far, wide angles cover large areas at short distances. We are happy to help determine the right output for your area.

LED Garden Lighting for Outdoor Areas

LED garden lighting stages paths, plants and water features after dark. This category includes inground spotlights for setting into terraces, driveways or lawns as well as underwater lights for ponds, pools and fountains. All fittings are made of stainless steel and protected to IP67 or IP68 depending on the location.

Most models run on 24 volt low-voltage technology, which makes operation outdoors and near water safe. As a planning rule: a few deliberately placed points of light usually work better than uniform continuous lighting. Matching drivers and cable connectors are available in our accessories category.

LED High Bay Lighting for Industry and Commerce

LED high bay lighting has to light large rooms with high ceilings reliably while operating economically. This category includes UFO high bay lights, linear high bay luminaires and canopy fittings for different ceiling heights and uses. Ceiling height, floor area and the type of work are decisive: in warehouses even base brightness matters most, at assembly workstations a low glare rating too.

The beam angle must match the height – narrower for high ceilings, wider for low ones. Compared with old mercury vapour or fluorescent installations, LED high bays often save more than half the energy costs. We are happy to support the design of your hall with a recommendation on quantity and layout.

LED Panels for Office, Practice and Retail

LED panels create a large, evenly lit surface instead of individual bright points. This makes them the standard solution for offices, medical practices, schools and meeting rooms where calm, low-glare light is wanted. We stock backlit panels, in which the LEDs sit behind the diffuser, and edgelit panels with side-fed light and an especially slim design.

The common sizes 60x60, 62x62, 120x30 and 120x60 centimetres are available to suit standard ceiling grids. For ceilings without a grid we offer surface mounting frames that allow direct installation. Watch the UGR value where screen work takes place – the lower, the more comfortable.

LED Track System for Retail and Commerce

An LED track system is the most flexible way to light sales areas. The luminaires are fitted onto the 3-phase busbar via an adapter and can be moved, added to or replaced at any time – with no electrical work at the ceiling. Using the three phases L1, L2 and L3 you switch several lighting groups separately, for example general light and shop window.

This category contains spotlights, linear luminaires, slim panels, food lighting and emergency fittings for the same track. Our adapters fit the common European systems such as Stucchi, Global, Staff, Unipro, Eutrac and Ivela as well as the EU universal standard. If your store layout changes, simply move the luminaires.

LED Street Lighting for Paths, Squares and Residential Areas

LED street lighting replaces old sodium and mercury vapour fittings while considerably reducing energy consumption. This category includes street lights for carriageways, post top luminaires for parks and residential areas, and lanterns in a classic style. All luminaires are protected to IP66 against dust and water jets and built for year-round outdoor use.

Many models allow power and colour temperature to be set by switch, so one fitting serves different situations. In residential areas warm light at 3000 K or below makes sense, as it disturbs residents and insects less. The adapters usually fit poles with 60 and 76 millimetre diameters.

LED Strips for Furniture, Display Cases and Light Lines

LED strips are flexible light bands that can be stuck to almost any surface. Use them to light display cases, shelves, furniture fronts, alcoves and ceiling edges – anywhere a normal luminaire would be too large. We stock two technologies: classic SMD strips with individual visible light points and COB strips that create a continuous, dot-free line of light.

For voltage you can choose between 24 volt low voltage, which needs a driver, and 230 volt strips run directly from the mains. Watch the power per metre: it determines both brightness and the size of driver required. Matching drivers, profiles and connectors are in our accessories category.

LED Accessories for Installation and Operation

A finished lighting project involves more than the luminaire itself. This category contains drivers for LED strips and fittings, motion sensors for retrofitting, brackets and pole adapters as well as cable and plug connectors. Drivers in particular deserve a careful look: the output must match the connected load and should offer around 20 percent headroom so the unit does not permanently run at its limit.

Motion sensors reduce energy costs where light is only needed occasionally – in corridors, stairwells and outdoor areas. Brackets and adapters ensure floodlights and street luminaires sit securely in the intended place. If you are unsure which accessory suits your fitting, just ask us.

DL6 LED recessed downlight 30W Ø 200mm 120° 4000K neutral white

Item number: DL630W-2

Category: DL6 LED Downlights

Lightcolor:: 3000K4000K6000K

26,90 €

including 19% VAT., plus shipping

From	Price per unit
4	25,99 €
8	25,49 €
12	24,99 €

Available

Shipping time: 2 - 3 workdays

Description

⚡ DL6 LED Downlight · 30 W · 4000 K Neutral White · Ø 200 mm

DL6 LED Recessed Downlight 30 W 4000 K Neutral White – 3000 lm · 120° · flicker-free

The round DL6 LED recessed downlight in neutral white (4000 K) as a flat recessed ceiling light for indoor use. 30 W deliver 3,000 lm at a 120° beam angle with an evenly lit surface – flicker-free, with a supplied constant-current driver.

30 W

POWER

3000

LUMEN

Ø 200 mm

CUT-OUT

4000 K

LIGHT COLOUR

Flicker-free recessed light with constant-current driver

Neutral white light (4000 K) is bright and natural – ideal for work and functional areas. The downlight starts instantly, flicker-free and without hum, and fits into a Ø 200 mm ceiling cut-out via spring clips.

Your Benefits at a Glance

Powerful brightness in Neutral White 3,000 lm in neutral white (4000 K) from 30 W.	Flicker-free & low-glare High-quality constant-current driver – pleasant light with no flicker or hum.
3 light colours Warm white (3000 K), neutral white (4000 K) and cool white (6000 K).	High efficiency Up to 100 lm/W, energy efficiency class F – economical to run.
Natural colour rendering Brilliant, natural colours thanks to CRI ≥ 80 Ra.	Easy installation Spring clips and a Ø 200 mm cut-out – LED driver included.

This Light Colour

Fixed light colour of this variant – also available in 3000 K, 4000 K and 6000 K.

4000 K Neutral White – offices, kitchens & work areas

Specifications

Property	Value
Power	30 W
Input voltage	AC 200–240 V (via LED driver)
Luminous flux	3,000 lm
Luminous efficacy	100 lm/W
Energy efficiency class	F (EU 2019/2015)
Light colour	4000 K (neutral white)
Colour rendering (CRI)	≥ 80 (Ra)
Beam angle	120°
LED type	SMD 2835 (60 pcs)
Driver	constant current, DC 36 V / 700 mA
Power factor	≥ 0.9
Protection rating	IP20
Protection class	III
Outer diameter	Ø 225 mm
Cut-out	Ø 200 mm
Recessed depth	63 mm
Weight	0.63 kg
Operating temperature	−20 °C to +50 °C
Lifespan	50,000 h
Certification	CE, RoHS

Installation & Wiring

The downlight is fitted into a Ø 200 mm ceiling cut-out and secured with the spring clips; the supplied LED driver is connected to 230 V (L = brown, N = blue). Keep a minimum distance of 0.2 m from flammable materials. Installation and wiring only by a qualified electrician with the power switched off.

Applications

Neutral white light fits functional areas: offices and meeting rooms, kitchens and retail spaces, schools and reception areas.

Why It Pays Off

Neutral white light (4000 K) is bright, clear and natural – the ideal choice for offices, kitchens, retail spaces and anywhere you need to see well. The DL6 downlight illuminates the area evenly and with low glare, providing pleasant work light without harsh shadows. Thanks to the constant-current driver and fixed LED module it starts instantly, flicker-free and without hum. Compared with halogen recessed spots you save up to 80 % electricity – noticeably lowering running costs. The slim body sits flush in the ceiling and looks modern and unobtrusive. Installation and wiring are done in minutes with the spring clips and included driver. With a 50,000-hour lifespan the downlight works reliably and virtually maintenance-free for years.

Scope of delivery: 1 × DL6 LED recessed downlight (30 W) with spring clips and external LED driver.